Workflow Stop/Break - Change History

Hi Team.

So, I have an Add Member to Group workflow. In the workflow, if certain conditions are met, I have a Stop/ Break, and the user is denied access to the group.

What I am trying to find is a method to record that this change took place even though the user was not added to the group. I have looked at adding a Report section either before or after the Stop / Break but nothing seems to show.

I just want to record that the change to add someone was denied.

Thanks in advance

Parents

0 Richard.Lambert 4 hours ago

Ultimately, no change takes place to the group so nothing will be seen on the group's Change History. As an alternative, entries for this are written to the Active Roles Event Log. Also, a report section can be added to record some information to then be sent to a mailbox.
Cancel
Up 0 Down

Reply

Verify Answer

Cancel

Reply

0 Richard.Lambert 4 hours ago

Ultimately, no change takes place to the group so nothing will be seen on the group's Change History. As an alternative, entries for this are written to the Active Roles Event Log. Also, a report section can be added to record some information to then be sent to a mailbox.
Cancel
Up 0 Down

Reply

Verify Answer

Cancel

Children

0 craig mcfarlane 4 hours ago in reply to Richard.Lambert

Thanks, Richard. I hoped to avoid sending an email and just have it quietly recorded in the change history.
Cancel
Up 0 Down

Reply

Verify Answer

Cancel