network changes to configure NON TRANSPARENT MODE in SPS

hello everybody i just need to know which kind of changes have to do the customer in their network to configure safeguard as TRANSPARENT MODE.

i know that all the traffic have to be sent first to SPS, so i think that it needed some routing configuration on the routing table in which all the network traffic from SPP (each request towards any target system managed from SPP) have to be routed to SPS, right?

is it enough? is there any other kind of specific configuration?

Thank you very much

0 Tawfiq.Ahmad over 2 years ago

Hi Dario,

If SPP is joined to SPS then transparent mode is not used and SPP sends all session traffic to SPS in non-transparent mode.

There are two options:

SPP initiated sessions (user logs in to SPP to request a session):

https://support.oneidentity.com/technical-documents/one-identity-safeguard-for-privileged-sessions/6.13.0/administration-guide/117#TOPIC-1766073

SPS initiated sessions (user logs in to SPS as gateway to connect to a session):

https://support.oneidentity.com/technical-documents/one-identity-safeguard-for-privileged-sessions/6.13.0/administration-guide/117#TOPIC-1766075

In Transparent mode, SPP is not used as per the graph here:

https://support.oneidentity.com/technical-documents/one-identity-safeguard-for-privileged-sessions/6.13.0/administration-guide/6#TOPIC-1765566

If this is a unique use case then I would suggest engaging Professional Services team for assistance.

Thanks!
Cancel
Up 0 Down

Reply

Verify Answer

Cancel